ADS-tec OPC5012 Instrukcja Użytkownika Pobierz pdf (Strona 19)

Industrial PCs OPC5012

7.5 NETWORK CONNECTION (RJ45)

If the required drivers are installed on the device, the control system can be integrated in

an Ethernet network with 10/100 Mbit support using the Ethernet 10/100BaseT network

connector and a suitable network cable. The specifications of the underlying network

topology are to be adhered to. The drivers required to use this function can be installed

from the provided service CD if needed.

1 8

PIN NUMBER SIGNAL NAME

TX +

TX -

RX +

RX -

7.6 SERIAL COM INTERFACE (RS232)

This interface should only be used for monitoring, debugging or a log printer because the

interface is not galvanically isolated.

PIN NUMBER SIGNAL NAME

DCD

RxD

TxD

DTR

GND

DSR

RTS

CTS

7.7 OPTIONAL USB CONNECTION ON THE FACEPLATE

A USB interface can optionally be accessible from the front. The interface is found under a

plastic cover to the right under the display. The cover has a tab on the right side, which

can be used to open it. The plastic cover is to be closed carefully after having used the

USB interface, because otherwise the protection class IP65 is not ensured on the front.

7.8 EXTERNAL DRIVES

There are no CD/floppy drives installed in the standard models of the device. However, the

system has a USB interface which can be used to connect an external drive. The devices

used for this purpose should always be suitable for industrial environments.

Warning:

It is not permissible to connect or disconnect an external drive while the device is

running, because it can not be ruled out that the drive is in use at this time. Non-

adherence can cause loss of data!

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25

Brak uwag

ADS-tec OPC5012 Instrukcja Użytkownika Strona 19